THE BENEFITS OF CUTTING-EDGE TECHNOLOGY

  • The casting process takes place in a fully controlled system with the
    following features:

    • execution with the use of Argon in a protected environment has the effect of greatly reducing oxidation of the alloy;
    • execution using vacuum casting allows thin thicknesses from 1-1.5 mm to be realised.
  • Possibility of producing complex shapes: with undercuts, closed volumes, geometries without demoulding.
  • Good dimensional tolerances.
  • Good surface finish.
  • High definition of details.
  • Short realisation times.
  • High mechanical features.
  • Repeatability of the process conditions and production results.
  • Flexible process (from the prototype to production).
  • Use of all low-melting alloys (e.g. A357, EN43500, etc.).

ITALIAN TECHNOLOGY FOR THE WORLDWIDE INDUSTRY

Our experience was born and bred in Italy, taking full advantage of the technical expertise of proven skills and commitments of professionals trained in a quality system, and who are in charge of the smooth and
proper functioning of each production phase.

AN INNOVATIVE AND RELIABLE PRODUCTION PROCESS

The production department has been set up in a new office provided with modern equipment specifically designed to take advantage of the investment casting method technology, which is carried out using a master specially made in the most appropriate material according to the features of the piece to be produced.

brochure

THE SERVICES ON WHICH YOU CAN DEPEND ON

Aluminium, zinc alloy and brass are the low-melting alloys we use to produce pieces made, meticulously
following the customer’s design, and finished with care.
In addition to the usual trimming and sanding, we offer a wide range of finishes that allow you to have castings
that are in-line with the customer’s requirements.
We also carry out welding, heat treatment, precision machining, and isostatic compacting services.

GREAT QUALITY SERIES AND PRODUCTIONS

The pieces obtained are completely reliable, used in the most varied sectors: aeronautical, automotive, defence, aerospace, medical, etc.

Development of the production technology and continuous process verification solve the problem of maintaining high quality in all of the pieces of the series, ensuring consistent performance even in those areas where a mechanical defect could have significant implications.

For this purpose, our quality control also involves verification of the pieces using X-rays to detect any imperfections that may be invisible to the naked eye.

Table Casting